Extron Electronics CC 200 Retractor - Manual (Page 2)

Bracket and Retractor Mounting
WARNING: Disconnect power from the Cable Cubby 200
power module before beginning installation.
1. Using the mounting bolt supplied with the CC 200 kit
(1/4-20 x 3 in), mount the CC 200 bracket to the retractor as
shown on the right. Do not overtighten the bolt.
Once the retractor is mounted to the bracket, the assembly can
be installed into the enclosure.
2. The cable stops and connecters may be too large to fit through
the AAP opening at the same time as the retractor. Pull a short
amount of cable out of the retractor and push it through the
AAP opening before installing the retractor/bracket assembly.
3. Press the bracket and retractor assembly against the bottom
of the enclosure, lining the bracket holes up with the AAP
mounting holes on the enclosure. Fasten from the top using
the supplied four screws.
4. Refer to the Cable Retraction System for Cable Cubby
Enclosures User Guide at
www.extron.com for further
retractor mounting instructions.
Mounting Screw
w/Washer (4 plcs)
Mounting Bolt
and Nut
CC 200
Bracket CC 200 Bracket and
Retractor Assembly
1
3
2
Extron USA - West
Headquarters
+800.633.9876
Inside USA and
Canada Only
+1.714.491.1500
+1.714.491.1517 FA
X
Extron USA - East
+800.633.9876
Inside USA and
Canada Only
+1.919.863.1794
+1.919.863.1797
FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656
FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566
FAX
Extron Middle East
+971.4.2991800
+971.4.2991880
FAX
© 2011 Extron Electronics All rights reserved. www.extron.com