Dvi 104 tx/rx • user guide, Troubleshooting – Extron Electronics DVI 104 TX_RX User Guide User Manual
Page 5
68-1549-01 Rev. D
12 13
Extron Headquarters
+800.633.9876 Inside USA/Canada Only
Extron USA - West
Extron USA - East
+1.714.491.1500 +1.919.
850.1000
+1.714.491.1517 FAX
+1.919.
850.1001 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
Extron India
1800.3070.3777
(Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
©
2013 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
DVI 104 TX/RX • User Guide
Troubleshooting
Display does not show an image
•
Ensure that all plugs and jacks used by the external power supplies are firmly
Normal Position
Adjusted Position
Locking catch
Release catch
connected.
If the cable is loose or slips out of the slot easily, move the release catch from its
normal position above the locking catch, to the adjusted position under the locking
catch (see the figure at right). This provides the extra leverage required to keep the
locking catch in place and hold the cable securely.
•
Ensure that the green LEDs for both the transmitter and receiver are on.
•
Ensure that the correct EDID information has been stored on the transmitter’s
EDID Minder. When using the DVI 104 Tx/Rx for the first time or if the display
device is changed, it is essential to set up the EDID Minder as described in
steps 1-6 of “
•
Ensure that the source device and output device are powered on and have booted correctly.
•
Ensure that the fiber optic cables are connecting the correct ports. A port on the transmitter must be connected to the same
numbered port on the receiver. For example,
port 1 of the transmitter must be connected to port 1 of the receiver.
•
Ensure that the fiber optic cable jacks are securely seated.
•
Ensure that the transmitter is firmly plugged into the source device and the receiver is firmly plugged into the output device.
•
Try resetting the system by unplugging and reconnecting the DVI connectors or the power jacks.
•
Try rebooting the computer.
Screen is distorted or displays noise
•
Ensure that the cable length does not exceed 500 meters (1,640 feet).
•
Ensure that the cables are high quality multimode cable and are terminated with securely fitting plugs.
•
Ensure that the graphic resolution is correctly set (see “
”).
•
View the “Display Properties” of the source device to check the output resolution. The resolution and refresh rate must match the
capabilities of the display device and must not exceed 1920 x 1200 at 60 Hz.
•
Try resetting the system by unplugging and reconnecting the DVI connectors or the power jacks.