Extron Electronics LockIt Cable Adapter Tether Kit - Manual

LockIt ™ Cable Adapter Tether Kit • Installation Guide
The LockIt Cable Adapter Tether provides a simple method to link cables and adapters together
to prevent them from being stolen or lost. To install the tether, follow these instructions and see
the figures at right.
© 2012 Extron Electronics All rights reserved. www.extron.com 68-2284-01 Rev A 07 12
2.0" (51 mm)
1b
1a
1. Thread one end of the nylon coated wire through a heat
shrink wrap (
Ä
) and the metal loop sleeve (
Å
), leaving
about 2 inches (51 mm) of free wire.
2. Loop the free end of the wire around the first cable to
be secured and thread the end of the wire back through
the metal loop sleeve (
b ).
3. Tighten the wire ( c ) until about 1/4 inch (6.4 mm) of
the short end extends past the metal sleeve ( Ñ ). To
avoid damaging the cable, allow about 1/8 inch (3.2 mm)
of space between the wire and the cable (
Ö
).
4. Crimp the metal loop sleeve with a pair of pliers to
secure the wire in place (
d
).
5. Slide the wrap over the metal loop sleeve (
e
) and
heat it to shrink it in place.
6. Repeat steps 1-5 to secure the other end of the wire to a
second cable (
f
).
2
4
6
1/4" (6.4 mm)
1/8" (3.2 mm)
3a
3b
3
5