Extron Electronics DVC-3 - Manual

68-1245-01
Rev. A
03 06
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Kyodo Building
16 Ichibancho
Chiyoda-ku, Tokyo 102-0082 Japan
+81.3.3511.7655
Fax +81.3.3511.7656 www.extron.com
Device A Device B
Female
9 pin D-sub
Male
9 pin D-sub
Female
9 pin D-sub
Female
9 pin D-sub
Tx
Tx Rx
Rx
A Rx/B Tx A Tx/B Rx
The cable assembly has four 9-pin D-sub connectors, interconnected as shown below;
DVC-3 Data View Communications Cable
The Extron DVC-3 Data View
Communications Cable can be inserted
between two RS-232 devices for
troubleshooting and monitoring (listening
into) the serial communications between
the two devices, without interrupting the
communications. The DVC-3 Cable is
terminated with female to male 9-pin
D-sub connectors for data pass through, with two additional female 9-pin D-sub connectors
used as the monitoring connections to your PC or laptop.
Using the cables
To use the Extron DVC-3 Data View Communications
Cable, unplug the RS-232 cables between the host
and controlled unit, and connect the DVC-3 cable
labeled with “Device A” and “Device B” connectors.
Connect one of the two monitoring cables to the PC
or laptop. The monitoring cable used will depend on
the communication line intended to be monitored.
The connector labeled “A Tx/B Rx” is for monitoring
the Tx (transmit) line of device A, which is also the
Rx (receive) line of device B, and the cable labeled
“A Rx/B Tx” is for monitoring the Rx (receive) line
of device A, which is also the Tx (transmit) line
of device B.
12V 0.5 A M AX
LA N
CO M 1
PC
Running Extron
DataViewer Software
Projector
RS-232
Send
Receive
Extron
IPL T S1
Ethernet Control
Interface with
GlobalViewer
™
software
Extron
DVC-3
DataView
Communication
Cable
Device A
Device B
Figure 1 Typical DVC-3 application