Extron Electronics LockIt HDMI Cable - Manual

3
4
3
1 2
Top Mounted Side Mounted Stacked
3
5
68-2093-01
Rev C 03 12
LockIt ® HDMI Cable Lacing Bracket Installation Guide
To securely fasten an HDMI cable to a device:
1. Plug the HDMI cable into the panel connection.
2. Loosen the HDMI connection mounting screw
from the panel enough to allow the LockIt lacing
bracket to be placed over it. The screw does not
have to be removed.
3. Place the LockIt lacing bracket on
the screw and against the HDMI
connector, then tighten the screw
to secure the bracket.
4. Loosely place the included tie wrap
around the HDMI connector and the
LockIt lacing bracket as shown.
5. While holding the connector securely
against the lacing bracket, tighten
the tie wrap, then remove any
excess length.
The LockIt HDMI lacing bracket can be used in a number of
different configurations as shown.
NOTE: The HDMI device must have an HDMI connection
mounting screw for this bracket to be used.
The Extron
®
LockIt lacing bracket makes it possible to simply and universally secure
a standard HDMI
®
cable to most HDMI devices.
NOTE: The tie wrap can also be tightened
using pliers or similar tools.
LockIt ® HDMI Cable Lacing Bracket Installation Guide, continued
CAUTION: Do not overtighten the
HDMI connection mounting screw.
The shield it fastens to is very thin
and can easily be stripped.