Xylem VARIO COND TEMPERATURE CONDUCTIVITY METERS - Manual (Page 39)

VARIO Cond Operation
39
4.10.4 Timer
The timer function can count down the seconds of a specified time interval
(timer intervall) of maximum 59:59 (minutes:seconds). When the specified
timer interval has expired, an alarm signal sounds for one minute and the
display flashes.
3 Display the current time as an intermediate time with < L >.
The intermediate time is displayed under the running stopwatch.
4 Stop the stopwatch with < g >.
5 Let it continue with < g >.
or
Reset the stopwatch to 00:00 with <
R >.
or
Terminate the stopwatch and switch to the measuring mode display
with <
E >.
1 Display the stopwatch with < U_ >.
The v status indicator appears.
The stopwatch is on 00:00.
2 Select the minutes or seconds with < 5_ > or < 6_ > [<Minutes> or
<Seconds>].
The selected display flashes.
3 Set the timer interval (minutes:seconds) with < > > and < < >.
The stopwatch has been converted to a timer.
4 Confirm the setting with < g >.
5 Start the timer with < g >.
6 If necessary, display the remaining time as an intermediate time with
<
L >.
nLF
Tref25
MEM
CAL
RCL
Sal
1 cm
K
C
2 5 8
S/cm
TDS
CellTC
S
SAL O
2
TC
RESET
Cell
LAP
m
mbar
mg/l
CAL
STO
LoBat Day.Month h:min Ident Lap
8
CLR
Lin
Tref20 Tref20
M cm
k cm
ESC
0 5 0 9
min:s