Xylem VARIO COND TEMPERATURE CONDUCTIVITY METERS - Manual (Page 37)

VARIO Cond Operation
37
4.10.2 Alarm function
With the alarm function you set a point of time (alarm time) at which an alarm
signal should sound. Prerequisite is the correct setting of the time (see
section 4.10.1).
The alarm signal also sounds when the meter is switched off.
Setting the alarm
time
1 Switch on the meter with < ( >.
After a short display test, a measured value is displayed.
2 Press < U > to indicate the time and date on the display.
The v status indicator appears.
3 Indicate the alarm time with < U >.
The alarm time appears on the display.
4 Select the hours or minutes with < 5_ > or < 6_ > [<Hours> or
<Minutes>].
The selected display flashes.
5 Set the alarm time with < > > and < < >.
6 Confirm with < g >.
The alarm time is set.
CLR
Ident
C
pH
mV
d
Day.Month
MEM
CAL
LoBat min:s Lap
RESET
LAP
ESC
0 0
- A L -
0 0
h:min