Xylem iRIS-CAM Wastewater Security Camera - Manual (Page 9)

i Quest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: +64 7 957 8160 Fax: +64 7 957 8162 Email: [email protected] 7
5 Configuration
5.1 iRIS 320 Configuration
Once the camera has been installed and commissioned using the PC interface the iRIS320 needs to be
programmed and configured.
5.1.1 Installing iRIS based Software
Installation of iRIS datalogger based software is achieved by using the iLink software package on a PC
connected to the logger via a null modem cable
2
.
1. Check the Firmware version is VN2.21 or higher, if it is, move onto step 2. If not follow these steps:
a. Obtain the latest version, iRIS320_XXX_YY.fls from iQuest, where XXX is the version
number (XXX=221 or higher), and YY is the PCB revision (YY=11 or 12).
b. Start iLink and connect to the logger
3
.
c. Select Tools->Advanced->Flash Executive menu option.
d. Click the top Browse button and locate the file obtained in step a.
e. Click Download button.
f.
When the download is complete, click OK button.
g. Click Start Flash Upgrade button.
2. Obtain the three iRIS 320 program files.
For a GPRS based iRIS:
iRIS_GPRS_ZZZ_1.irs
iRIS_GPRS_Camera_ZZZ_2.irs
iRIS_GPRS_ZZZ_3.irs
For a CDMA based iRIS:
iRIS_CDMA_ZZZ_1.irs
iRIS_CDMA_Camera_ZZZ_2.irs
iRIS_CDMA_ZZZ_3.irs
Note: Where the ZZZ is the software version number.
3. Start iLink and connect to the logger
3
.
4. Click the Program toolbar button (or Tools->Program menu option).
5. Click Stop Programs button.
6. If the existing logger data and configuration are no longer required click the Clear Device Button.
Otherwise proceed to the next step.
7. Click the Browse button and select the first file obtained in step 2.
8. Click the Download button.
9. When the download is complete, press the OK button.
10. Repeat steps 7, 8 and 9 with the second and third files obtained in step 2.
11. When all three banks are downloaded, click the Start Programs button.
This completes the installation of camera specific software and firmware. The next thing to do is to
configure the iRIS to take images.
2
See iRIS320 User Guide for more information on the logger to PC connections.
3
See the iLink manual for information on how to connect to data loggers.