Xylem iRIS-CAM Wastewater Security Camera - Manual (Page 5)

i Quest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: +64 7 957 8160 Fax: +64 7 957 8162 Email: [email protected] 3
2 Overview
2.1 Introduction
The iRIS-CAM is a camera accessory for the iRIS 320 data logger. It is supplied in an environmentally
sealed (IP65) enclosure constructed from a special corrosion-resistant aluminium alloy that is finished in a
hard-anodised coating. This provides a very high degree of mechanical strength and EMI shielding, and
enables completely stand-alone mounting in outdoor situations. The enclosure is filled with epoxy resin
and the lens is silicon greased in place, which means the potential for water ingress is extremely low.
When connect to an appropriately configured iRIS320 data logger, images can be taken, stored and then
unloaded (at regular intervals) via any of the communication channels available to the iRIS (e.g. GPRS,
CDMA, RS232, CSD).
2.2 Specifications
SIZE:
162mm x 116mm x 65mm (4.60in x 6.37in x 2.64in) (WxHxD)
CONNECTORS:
6 way rectangle connector on the end or 5m of shielded PVC cable
MASS:
300 g (10.6oz)
POWER SUPPLY:
3.3V d.c +/- 10% (powered via cable from iRIS)
RESOLUTION:
Selectable 80x60, 160x128, 320x240 or 640x480 pixels JPEG format,
24 bit colour
LENS:
F2.8
Focal length 4mm
Integral IR filter
ENVIRONMENTAL: Operating: -10 °C to +70 °C (14 °F to +158 °F)
Storage: -10 °C to +85 °C (14 °F to +185 °F)
Enclosure sealed to IP67