Xylem A-100NE CHEMICAL PUMPS - Manual (Page 3)

2.0 Specifications
Maximum Working Pressure 100 psig / 6.9 bar (most models)
o o
Maximum Fluid Temperature 130 F / 54 C
o o
Ambient Temperature Range 14 to 110 F / -10 to 43 C
Duty Cycle Continuous
Maximum Solids 50% by volume
Maximum Viscosity 5,000 Centipoise
Maximum Suction Lift up to 30 ft. water
Power Requirements 115V60Hz 80 Watts,
220V50Hz 40 Watts,
230V60Hz 45 Watts
Dimensions 6-1/8” H x 10-1/8” W x 9” D
Weight 8 lb.
4.0 Unpacking
Your pump package should contain the following:
1 - Injector pump with 2 pump tube assemblies
1 - suction tube strainer
1 - ceramic tubing weight
1 - 5’ Length of clear PVC suction tubing
1 - 5’ Length of opaque LLDPE discharge tubing
1 - Injection fitting with internal back-flow check valve
1 - Mounting hardware kit
1 - Shroud (weather proof cover see page 10)
3.0 Features
!
Peristaltic Pump Tube does not require valves.
!
Self priming. Cannot vapor lock.
!
High outlet pressure capability of 100 psig.*
!
High inlet suction lift capability of 30 feet.
!
Patented Tube Failure Detection (TFD)system.
!
Patented pump tube assembly design.
!
Digital electronic feed rate control.
!
Pump Tube service warning timer.
!
Corrosion proof Valox housing.
!
Tamper resistant electronic control panel cover.
A-100NE
Page 3
1.0 Introduction
Thank you for purchasing the A-100N Model E Peristaltic Metering Pump.
The A-100N is designed to inject chemicals into piping systems. The pump
has been tested by NSF International for use with 12 ½% Sodium
Hypochlorite. The Model E is equipped with external input control circuitry
which allows the pumps output to be externally controlled by either a 4-
20mA input signal, a 0-10V DC input signal or a pulsed input signal.