Xylem H-3553 - Manual (Page 28)

H-3553 Combo Bubbler setup menu sDI-12 Interface
P – Advanced Options Command: aXWMRnnn!
: Response: a0021
advanced Options menu Command: aXRMR!
R - Measure Rate: xx Response: a0021
Enter Measure Rate (0 - 255) [nnn ] Command: aD0!
Response: a + nnn
Table 4-21: Change the H-3553 Measure Rate
SETUP & OPERATION
26
Test Display
If the display seems to be displaying numbers incorrectly, the Test Display command can be used to verify the
individual segments are working properly. This command cycles the numbers 0-9 in each number location
then displays 100.000, 1000.00, and 10000.0 to ensure the decimals are also working properly.
Help
The Help command outputs a complete list of commands that this unit supports. The response is not SDI-12
compliant but many devices in a transparent mode can display the table of commands.
Setup and Operation Conclusion
This chapter has focused on the setup and operation of the H-3553. Although there are many settings,
most applications will work just fine with the default settings. WaterLOG has put great efforts in testing and
adjusting the default settings to fit most applications, therefore try using the default settings, and then make
adjustments as needed.
The option that will probably be of most importance in this chapter is the “Set Current Stage” section. Once
the H-3553 is mounted and installed, the last thing to do is set the current stage. All the other settings found
in this chapter will only need to be changed if the default settings will not work for the application.
And of course, with all WaterLOG equipment, if there is ever a question or more explanation needed or a
problem that needs extra assistance call or email us and we will gladly assist you with the product.
Phone: 435-753-2212
Email: [email protected] or [email protected]