YSI IQ S ENSOR N ET MIQ/C6 - Manual (Page 12)

Installation MIQ/C6
3 - 4 ba76033e01 01/2012
Connecting lines to the
terminal strip
Fig. 3-1 Terminal strip with the current connections
1 Open the module.
2 Open the dummy screw fitting under the required connection.
Keep the dummy screw fitting for possible later modifications.
3 Screw the cable gland (pos. 1 in Fig. 3-1) with the sealing ring
(pos. 2) into the module housing.
4 Loosen the coupling ring (pos. 3 in Fig. 3-1).
5 Feed the line through the cable gland in the module housing.
6 Connect the wires to the terminal strip. While doing so, pay
attention to the specifications on the label located under the
terminal strip.
7 Tighten the coupling ring (pos. 3 in Fig. 3-1).
8 Close the module.
1
3
2
Current outputs
X18
+ REC3 - + REC6 - + REC2 - + REC5 - SENSORNET 2 SENSORNET 1 + REC1 - + REC4 -
ON
OFF
0/4...20mA 0/4...20mA 0/4...20mA 0/4...20mA 0/4...20mA 0/4...20mA
X17 X16 X15 X14 X13 X12 X11 X10 X8 X9 X7 X6
RED RED
SN
TERMINA
TO
R
GREEN SHIELD GREEN
X5 X4 X3 X2 X1
SHIELD