YSI IQ S ENSOR N ET MIQ/C6 - Manual (Page 11)

MIQ/C6 Installation
3 - 3 ba76033e01 01/2012
General installation
instructions
Observe the following points when attaching connecting wires to the
terminal strip
 Shorten all wires to be used to the length required for the installation
 Always fit all the ends of the wires with wire end sleeves before
connecting them to the terminal strip

Any wires that are not used and project into the enclosure must be
cut off as closely as possible to the cable gland.
 Screw a small cable gland with sealing ring into each remaining free
opening and close it with a blind plug.
3.4 Connections to the current outputs
Materials required  Wire end sleeves, suitable for the connecting wires, with suitable
crimping tool
 4 x cable gland with sealing ring (scope of delivery MIQ/C6)
Tools

Cable stripping knife
 Wire stripper

Phillips screw driver
 Small screw driver