YSI NiCaVis 701 IQ NI - Manual (Page 16)

Commissioning
NiCaVis 70x IQ NI
3 - 6 ba76132e01 03/2013
Connecting the sensor to
the sensor connection
cable
Fig. 3-5 Connecting the sensor
1. Take the protective caps off the plug connections of the sensor
and the SACIQ (SW) sensor connection cable and keep them
safe.
2. Plug the socket of the SACIQ (SW) sensor connection cable
onto the plug head connector of the sensor. At the same time,
rotate the socket so that the pin in the plug head connector (1)
clicks into one of the two holes in the socket.
3. Then screw the coupling ring (2) of the sensor connection
cable onto the sensor up to the stop.
SACIQ (SW)
1
2