Settings of the secondary sensor (tss measure, Ment) – YSI CarboVis 705 IQ TS User Manual
Page 23
CarboVis 70x IQ TS
Commissioning
3 - 13
ba75950e02
11/2012
Fig. 3-7 140 - Settings of sensors and diff. sensors (virtual sensor)
3.4.5 Settings of the secondary sensor (TSS measurement)
Carrying out settings
Using , switch from the measured value display to the main menu
of the settings. Then navigate to the setting menu (setting table) of the
sensor. The procedure is described in detail in your IQ S
ENSOR
N
ET
system operating manual.
Default values are marked in bold.
Save and quit
-
The system confirms the saving of the
settings and the display switches to the
next higher level.
Quit
-
The display switches to the next higher
level without saving the new settings.
Menu item
Settings
Explanations
Menu item
Settings
Explanations
Measuring mode
TSS
Display of the measuring mode
(TSS = total suspended solids measure-
ment)
Measuring range
-
Display of the measuring range
).
Cal - # raw value 1
Value pairs of the user calibration for TSS measurement (see section
Note: Leave those values unchanged during the initial commission-
ing.
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2