YSI CarboVis 705 IQ TS - Manual (Page 20)

Commissioning
CarboVis 70x IQ TS
3 - 10 ba75950e02 11/2012
Menu item Settings Explanations
Measuring mode

COD spectr., total

COD spectr., dissolv

TOC spectr., correl.

BOD spectr., correl.
 DOC spectr., correl.
 SAC 254, total

SAC 254, dissolved

UVT 254
The measured parameter is displayed
in the selected citation form.
When changing the Measuring mode
setting, always check the Measuring
location setting.
If the previously set measurement loca-
tion is not available for the selected
measuring mode, the measurement
location is automatically changed..
Measuring location

Outlet

Inlet

Activation
Measurement location or application of
the sensor.

The possible measurement loca-
tions are displayed depending on the
currently set measuring mode.
 The sample matrix on which the cal-
culation of the measured value is
based changes with the location of
the sensor.
The measurement location Activation
can only be selected for Measuring
mode COD spectr., dissolv .
Measuring range - Display of the measuring range
(see chapter 8 T
ECHNICAL DATA
).
Cal - # raw value 1 Value pairs of the user calibration (see section 4.3.2).
Note: Leave those values unchanged during the initial commission-
ing.
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
Zero adjustment
Factory
User
Setting of which zero adjustment is
used in the sensor.

Factory zero adjustment or
 Zero adjustment carried out last
Signal smoothing

On

Off
Switching on/off the signal smoothing.
For more details, see Response time
t90 .