YSI 30 - Manual (Page 22)

Advanced Setup Section 6
YSI, Incorporated Model 30/30M 18
rErr
mS
24.8 °C
If this happens, simply press and release the ENTER key until a range is selected which is suitable
for your sample. If you get lost and don’t know if you’re in a manual range or autoranging, simply
turn the instrument off and back on. The instrument will always default to autoranging when first
turned on.
Model 30M
While you are making conductivity or specific conductance measurements with the Model 30M,
simply press and release the UP ARROW key to select manual ranging. Note that the conductivity
units will flash on the Model 30M to indicate that the instrument is in a manual range.
1014
µS
24.8 °C
CAL
Each additional press of the UP ARROW key will cycle the Model 30M to a different manual range
until you return again to autoranging. Five pushes of the UP ARROW key will cycle the Model
30M through the four manual ranges and return the instrument to autoranging.
NOTE: You may see an error message in some manual ranges if the manual range selected is not
adequate for the sample you are measuring.
rErr
mS
24.8 °C
30M ONLY: Flashing
units indicate manual
range
Range error
message
Range error
message