YSI 30 - Manual (Page 14)

Saving Data Section 4
YSI, Incorporated Model 30/30M 10
4.2 RECALLING STORED DATA
1. To put the Model 30M into the RECALL mode, press the MODE key until rcl is displayed on
the screen along with the site ID number in the lower right corner.
rcl
01
2. Press the ENTER key to review the last set of data that was saved. The Model 30M will display
the conductivity and temperature. Another press of the ENTER key will display the specific
conductance and the temperature. Press the ENTER key again to review the salinity which is
also displayed with the temperature.
3. Press the UP ARROW key to increment through the saved sets of data.
4. Press the DOWN ARROW key to decrement through the saved sets of data.
NOTE: The Model 30M will recall data as a list. When the UP ARROW is pressed the Model 30M
will display the Site ID# for the previously recorded data. For example: If you are reviewing Site
ID# 5 and the UP ARROW is pressed, the Model 30M will display Site ID# 4. If you are reviewing
Site ID# 5 and Site ID# 5 was the last set of data stored, the DOWN ARROW key will display Site
ID# 1.
Here is an example of the Model 30M memory.
Site ID #1
Site ID #2
Site ID #3 If the UP ARROW key was pressed the Model 30M would display Site ID #2
Site ID #4
Site ID #5
4.3 ERASING STORED DATA
1. To erase the data that is stored into the Model 30M’s memory, press the MODE key until the
Model 30M displays ErAS on the screen.
ErAS
Site identity