Xylem handylab pH LF 12 - Manual (Page 57)

handylab pH/LF 12 Operation
57 ba75370e03 11/2009
4.7 Transmitting data
You have the following possibilities of transmitting data:
z One of the following options:
– With the AutoStore function (page 49), measured values are
periodically saved internally (save interval Int 1) and output on the
interface.
– With the Data transmission interval function (Int 2), measured values
are periodically output on the interface (see below).
z With the Output data storage function (page 51), calibration data or saved
measured values are output on the interface.
4.7.1 Data transmission interval (Int 2)
The interval to the data transmission (Int 2) determines the chronological in-
terval between automatic data transmissions. After the selected interval ex-
pires, the current data record is transmitted to the interface.
Note
The setting of the interval (Int 2) is only effective if the save interval
(AutoStore function) is switched off!
Setting the
Data transmission
interval
The default setting for the interval is OFF.
To start the data transmission, set an interval (5 s, 10 s, 30 s, 1 min, 5 min,
10 min, 15 min, 30 min, 60 min):
1 Press the key and hold it down.
2 Press the key. Int 2 appears on the display.
3 Set the required interval between the saving procedures with
<
▲> <▼>.
4 Confirm with .
The measuring instrument switches to the last active measur-
ing mode.
Store Auto
LoBat
Tref25
nLF
/ K %
RCL
Sal
°
AR
TP
C
M
m
% mg/l
cm
S/ cm
S
8 cm 1/
° F
ARng Cal Lin
Tref20
Sal TDS
mbar
O UpH
mV/pH
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Ident Year
F F O
t 2 n 1