Xylem handylab pH LF 12 - Manual (Page 51)

handylab pH/LF 12 Operation
51 ba75370e03 11/2009
4.6.3 Outputting the data storage
You can output the contents of the data storage:
z Stored data on the display
z Calibration data on the display
z Stored data on the serial interface
z Calibration protocol to the interface
Outputting stored
data on the display
You can perform the following activities:
1 Press the key repeatedly until StO dISP appears on the
display.
2 Press the key.
A measured value appears on the display.
The storage location of the data record is displayed for approx.
2 s, then the respective temperature appears.
Display further data of the data record
(ID number, date, time, storage location) Press
Toggle between two saved measured
variables Press
+
Advance one data record
(storage location) Press <
▲>
Go back one data record (storage location) Press <
▼>
ARng ConCal
Store Auto
0
No.
LoBat
Day.Month
Year Ident
UpH
AR
%
°F
°C TP
mV/pH
mol/L
TempError AutoCal DIN CalError
AutoCal TEC
Time Baud
1 S
mg/L
% ppm
ISE
O sT
p i s
RCL
d
AR
Store
No. Day.Month
Year Ident
ARng
%
O U
m
Sal
mg/l
8
LoBat
Time Baud
Sal
mbar
1 S
Auto
Cal
° F
1/cm
/ K %
TDS
mV/pH
S/
cm
cm M
Lin
Tref25 Tref20
nLF
AutoCal DIN
AutoCal TEC
8
8 8 6
pH
RCL
TP
2 4
° C