Xylem CG 843 - Manual (Page 42)

Operation
110
4.4.3 Outputting the data storage
The contents of the data storage can be output to the:
l display
l RS interface
You can perform the following activities:
Note
If you want to find a specific parameter (e.g. date), proceed
as follows:
1 Press the key repeatedly until Sto disp ap-
pears on the display.
2 Press the key.
A measured value appears on the display.
The memory location of the data store appears for
approx. 2 s. This is followed by the corresponding
temperature.
Display further parameters of the data
record (I.D. no., date, time, memory loca-
tion) Press
Advance one data record (memory location) Press < ▲ >
Go back one data record (memory location) Press < ▼ >
Outputting to the
display