Bell & Gossett V1000266 Series CRS Coalescing Removal Separator User Manual

Page 8

8200 N. Austin Ave.

Morton Grove, IL 60053

Tel: (847) 966-3700

Fax: (847) 966-9052

www.bellgossett.com

7. Properly assembled separator components will immediately seal to moderate pressure (100 PSI or less). For maximum

pressure resistance, allow the Loctite 567 or RectorSeal No. 5 thread sealant to cure for 24 hours. PTFE tape typically

does not require curing to achieve maximum pressure resistance.

Loctite and Loctite 567 are registered trademarks of Henkel AG & Co. RectorSeal No. 5 is a registered trademark of

RectorSeal Corporation.

NOTICE: Over application of torque may cause damage to the Separator or accessory component.