Acer Altos G530 - Manual (Page 185)

175
Configuring the SCSI/SCSI RAID HBA
This section shows how to create a RAID 1 (mirror) volume. This feature
requires the installation or presence of a LSI Logic
1020A SCSI
controller.
Using the SCSI HBA setup utility
During bootup, press Ctrl+C to enter the LSI Logic Configuration
screen.
Loading the HBA default settings
1 In the LSI Logic MPT SCSI setup screen, press F2.
2 Select Global Properties, then select Restore Defaults.
3 Press Esc, then select Save changes then exit this menu.
4 Select 53C1020/53C1030, then press Enter.
5 Select Restore Defaults, then press Enter.
6 Press Esc, then select Save changes then exit this menu.
Using the SCSI RAID HBA setup utility
Creating a RAID 1 volume with a hot spare disk
1 In the LSI Logic MPT SCSI setup screen, select 53C1020/53C1030,
then press Enter.
2 Select RAID Properties, then press Enter.
3 In the Array Disk field, press the spacebar.
If you change the settings in the Array Disk field, the following
messages appear:
F3 - Keep Data (Create 2 disk arrays)
Delete - Erase Disk (Create 2 to 6 disk arrays)
4 Press the Delete key to erase all data on the screen.
5 In the Hot Spare field, press the spacebar.