Acer Altos G530 - Manual (Page 108)

4 BIOS setup 98
USB Mass Storage Device Configuration
The USB Mass Storage Device Configuration submenu lets you specify
settings for a USB mass storage device, such as a USB CD-ROM,
CD-ROM/RW, DVD combo drive, and hard disk drives.
USB 2.0
Controller Enables the USB 2.0 controller. Enabled
Disabled
USB 2.0
Controller
Mode Sets the transfer rate at HiSpeed (480
Mbps) or FullSpeed (12 MBps). HiSpeed
FullSpeed
USB Mass
Storage Device
Configuration Lets you specify the settings of the USB
mass storage class devices.
Press Enter to access the USB Mass
Storage Device Configuration submenu.
Parameter Description Option
USB Mass
Storage Reset
Delay Select the number of seconds POST waits
for the USB mass storage device after the
start unit command. 20 Sec
10 Sec
30 Sec
40 Sec
Device #1 Type of USB mass storage device.
Emulation
Type When set to Auto, USB mass storage
devices with less than 530 MB will be
emulated as a floppy and the remaining
drives are hard drives.
The Forced FDD option can be used to
force a formatted HDD to boot as a FDD.
Auto
Floppy
Forced FDD
Hard Disk
CD-ROM
Parameter Description Option