Acer S5201 - Manual (Page 45)

45
Eng
lis
h
Display over USB
Introduction
Display over USB (DoUSB) projection is an easy-to-use function to project a
computer’s screen using a single USB cable (USB type A to mini USB) without
needing any drivers.
If you unplug the USB cable, the projector will stop projecting and revert to
standby status.
How to start DoUSB
1 Set the projector source to USB B . The screen below will be shown.
2 Connect the USB cable to the projector and computer: Plug the mini USB
into the projector and type A USB into the computer.
3 Unplug the USB cable to stop DoUSB.
Note: Only one computer can be connected at a time.
Support All PC Screen Resolutions
Through an auto-detecting and auto-adjusting/auto-stretching algorithm, all
NB/PC screen resolutions can be supported and wirelessly projected.
•
If the current resolution setting at the NB/PC side is smaller than the
current projector resolution, APG will adjust the current NB/PC resolution
to the optimum projection resolution in order to project the best image.
• If the current resolution settings of the NB/PC and projector are the same,