AEG HC452020EB - Manual (Page 28)

– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metal-
lic discolorations. Use a special
cleaning agent for glass ceramic
or stainless steel.
2. Clean the appliance with a moist
cloth and some detergent.
3. At the end rub the appliance dry
with a clean cloth.
7. TROUBLESHOOTING
Problem Possible cause Remedy
You cannot activate or
operate the appliance. The appliance is not
connected to an electri-
cal supply or it is con-
nected incorrectly. Check if the appliance is
correctly connected to
the electrical supply (refer
to connection diagram).
Activate the appliance
again and set the heat
setting in less than 10
seconds.
You touched 2 or more
sensor fields at the same
time. Touch only one sensor
field.
The STOP+GO function
operates. Refer to the chapter “Dai-
ly Use”.
There is water or fat
stains on the control
panel. Clean the control panel.
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated. You put something on
one or more sensor
fields. Remove the object from
the sensor fields.
The appliance deacti-
vates. You put something on
the sensor field
.
Remove the object from
the sensor field.
The residual heat indica-
tor does not come on. The cooking zone is not
hot because it operated
only for a short time. If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
The Automatic Heat Up
function does not oper-
ate. The cooking zone is hot. Let the cooking zone be-
come sufficiently cool.
The highest heat setting
is set. The highest heat setting
has the same power as
the Automatic Heat Up
function.
28 www.aeg.com