AEG HC452020EB - Manual (Page 24)

acoustic signal sound some time and
the appliance deactivates. Remove the
object or clean the control panel.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
comes on and the appliance
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off
function:
•
, - — 6 hours
• - — 5 hours
•
- — 4 hours
• - — 1.5 hours
4.3 The heat setting
Touch the control bar at the heat set-
ting. Move your finger along the control
bar to change the setting. Do not re-
lease before you have a correct heat set-
ting. The display shows the heat setting.
4.4 Activation and
deactivation of the outer rings
You can adjust the surface you cook to
the dimension of the cookware.
To activate the outer ring touch the sen-
sor field
. The indicator comes on.
For more outer rings touch the same
sensor field again. The subsequent indi-
cator comes on.
Do the procedure again to deactivate
the outer ring. The indicator goes out.
4.5 Automatic Heat Up
You can get a necessary heat setting in a
shorter time if you activate the Automat-
ic Heat Up function. This function sets
the highest heat setting for some time
(see the diagram), and then decreases to
the necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1. Touch ( comes on in the dis-
play).
2. Immediately touch the necessary
heat setting. After 3 seconds
comes on in the display.
To stop the function change the heat
setting.
1
2
3
4
5
6
7
8
9
10
11
12
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14
4.6 The Timer
The Count Down Timer.
Use the Count Down Timer to set how
long the cooking zone operates for only
this one time.
Set the Count Down Timer after the
selection of the cooking zone.
The selection of Timer function is
possible for cooking zones that
are active and the heat setting is
set.
• To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on.
When this function is activated,
comes on.
• To activate the Count Down Timer:
touch of the timer to set the time (
00
-
99
minutes). When the indicator
of the cooking zone starts to flash
slow, the time counts down.
• To see the remaining time: set the
cooking zone with . The indicator
of the cooking zone starts to flash
quickly. The display shows the remain-
ing time.
24 www.aeg.com