Zabg4002, New prod uc t, Applications circuit – Diodes ZABG4002 User Manual
Page 5: Applications information
ZABG4002
ZABG4002
Document number: DS32047 Rev. 2 - 2
5 of 7
February 2010
© Diodes Incorporated
NEW PROD
UC
T
A Product Line of
Diodes Incorporated
Applications Circuit
Applications Information
Above is a partial applications circuit for the ZABG4002 showing all external components needed for biasing one of the four FET
stages available. Each bias stage is provided with a gate and drain pin. The drain pin provides a regulated 2.0V supply that
includes a drain current monitor. The drain current taken by the external FET is compared with a user selected level, generating a
signal that adjusts the gate voltage of the FET to obtain the required drain current. If for any reason, an attempt is made to draw
more than the user set drain current from the drain pin, the drain voltage will be reduced to ensure excess current is not taken.
The gate pin drivers are also current limited.
The bias stages are split up into two pairs, with the drain current of each pair set by an external R
CAL
resistor. R
CAL
1 sets the drain
currents of stages 1 and 3, whilst R
CAL
2 sets the drain currents of stages 2 and 4. This allows the optimisation of drain currents for
differing tasks such as input stages where noise can be critical and later amplifier stages where gain may be more important. A
graph showing the relationship between the value of R
CAL
and I
D
is provided in the Typical Characteristics section of this
datasheet. The R
CAL
pins can also be used as logic inputs. If set to a logic high state (>3.0V), the associated FET bias stages are
disabled, driving gate pins to -2.5V and switching drain pins open-circuit. This feature can be used as part of a power
management system that turns off any unwanted stages in a multi input receiver.
The ZABG4002 includes a switched capacitor DC-DC converter that is used to generate the negative supply required to bias
depletion mode FETs used in common source circuit configuration as shown above. This converter uses two external capacitors,
C
NB
the charge transfer capacitor and C
SUB
the output reservoir capacitor. The circuit provides a regulated -2.5V supply both for
gate driver use and for external use if required (for extra discrete bias stages, mixer bias, local oscillator bias etc.). The -2.5V
supply is available from the C
SUB
pin.
If any bias stages are not required, their gate and drain pins may be left open circuit. If all bias stages associated with an R
CAL
resistor are not required, then this resistor may be omitted.
To ease PCB layout, the pinout for the ZABG4002 includes two Vcc pins. These pins are internally connected so only one of the
pins needs to be powered for the device to function. It is probable that the extra pin will help avoid the need for trace cross-over
components or ground plane disruption from reverse side PCB links. Note that the exposed pad of the package must be either left
floating or connected to Csub.
JF1
Vcc
L*
L*
C*
C*
C1
10nF
C2
10nF
CNB
47nF
CSUB
47nF
RCAL2
39k
* Stripline Elements
ZABG4002
RCAL1
39k
G2
Cn
b
1
Vcc
Gnd
Cn
b
2
G1
D3
Vc
c
D1
G3
D2
D4
Csu
b
Rca
l2
G4
Rcal1