AVSL 152.765 THE FLY - Manual (Page 13)

152.763UK User Manual
DMX mode
The fixture is equipped with 3-pin XLR connectors for DMX input and output. These connectors
are wired in parallel. Only use a shielded twisted-pair cable designed for 3-pin XLR-plugs and
connectors in order to connect the controller with the fixture or one fixture with another.
Building a serial DMX-chain:
Caution: At the last fixture, the DMX-cable has to end with a terminator.
Solder a 120 Ohm resistor between PIN 2 (-) and PIN 3 (+) into a 3-pin XLR-plug and plug it in
the DMX-output of the last fixture.