AVSL 152.765 THE FLY - Manual (Page 12)

152.763UK User Manual
Remote control mode
THE FLY laser can be operated using the supplied handheld infra-red remote control.
To use this remote control, firstly, remove the plastic tab at the bottom of the remote to
activate the internal battery. If necessary, this can be replaced with a standard CR2025 button
cell.
The Remote mode for the laser unit is set via the control panel as follows…
 Press the FUNC button until  is displayed and press ENTER
 Direct the handheld remote control toward the I.R receiver on the front panel
 See the remote control options below for operation
Remote handset
Note: When sound-activated mode is selected from the remote control…
Press “Sound-activated”… then “B”… then a number from 1 to 9 to set microphone sensitivity.
Test mode
THE FLY laser can produce a fixed cross pattern for testing size and projection against a
surface for adjustment and positioning. To enter the test mode, press the FUNC button until
the display shows
 and press ENTER.