Asus ESC500 G3 - Manual (Page 40)

Chapter 2: Hardware setup 2-20
3. Secure the SSD in place with four
screws.
Swing the drive cage
outwards to access the two
screw holes on the other side
of the drive cage.
4. Connect a 7-pin SATA cable
(from the motherboard SATA
port) and a 15-pin power plug
(from the power supply unit) to
the rear connectors of the SSD.
Use either the 15-pin SATA power connector or the legacy 4-pin power
connector. Do not use both types of power connectors to prevent damage to
components.