3 setting the raid mode in bios, 4 raid configuration utilities, 2 installing hard disk drives – Asus ESC500 G3 User Manual
Page 139
5-3
ASUS ESC500 G3
5.1.3
Setting the RAID mode in BIOS
You must set the RAID mode in the BIOS Setup to be able to launch the RAID utilities before
you can create a RAID set from the SATA hard disk drives attached to the SATA connectors.
To do this:
1.
Enter the BIOS Setup during POST.
2.
Go to the Advanced Menu > SATA Configuration, then press
3.
Set SATA Mode to [RAID].
4.
Press
Refer to Chapter 4 for details on entering and navigating through the BIOS Setup.
5.1.4
RAID configuration utilities
Depending on the RAID connectors that you use, you can create a RAID set using the utilities
embedded on each RAID controller. The P9D motherboards support Intel
®
Rapid Storage
Technology for setting up RAID.
5.1.2
Installing hard disk drives
The motherboards support Serial ATA for RAID set configuration. For optimal performance, install
identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for RAID configuration:
1.
Install the SATA hard disks into the drive bays following the instructions in the system
user guide.
2.
Connect a SATA signal cable to the signal connector at the back of each drive and to the
SATA connector on the motherboard.
3.
Connect a SATA power cable to the power connector on each drive