Asus ESC500 G3 - Manual (Page 140)

5-4 Chapter 5: RAID configuration
5.2 Intel ® Rapid Storage Technology Enterprise Option
ROM Utility
The Intel ® Rapid Storage Technology enterprise Option ROM utility allows you to create RAID
0, RAID 1, RAID 10 (RAID 1+0), and RAID 5 set(s) from Serial ATA hard disk drives that are
connected to the Serial ATA connectors supported by the Southbridge.
The navigation keys at the bottom of the screen allow you to move through the menus
and select the menu options.
The RAID BIOS setup screens shown in this section are for reference only and may not exactly
match the items on your screen.
You may have to press + more than once to enter the main menu.
To launch the Intel ® Rapid Storage Technology enterprise Option ROM utility:
1. Turn on the system.
2. During POST, press to display the utility main menu.
Before you proceed, ensure that you have installed the Serial ATA hard disk drives, have set
the correct jumper settings of the motherboard, and have set the correct SATA mode in the
BIOS setup. You can refer to sections 5.1.2 Installing hard disk drives and 5.1.3 Setting
the RAID mode in BIOS for more information.
[ESC]-Exit [ENTER]-Select Menu [ ]-Select
Intel(R) Rapid Storage Technology enterprise - SATA Option ROM - 3.6.0.1023
Copyright(C) 2003-12 Intel Corporation. All Rights Reserved.
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION ]
RAID Volumes:
None defined.
Physical Disks:
ID Drive Model Serial # Size Type/Status(Vol ID)
0 ST3300656SS HWAS0000991753TR 279.3GB Non-RAID Disk
1 ST3300656SS 37VN00009846RAJ1 279.3GB Non-RAID Disk
2 ST3300656SS 397600009846UEDY 279.3GB Non-RAID Disk
3 ST3300656SS GWC50000991756G6 279.3GB Non-RAID Disk
3. Reset Disks to Non-RAID
4. Exit
1. Create RAID Volume
2. Delete RAID Volume