Asus P4U800-X - Manual (Page 44)

2-12 Chapter 2: BIOS information
HDD S.M.A.R.T. Capability [Disabled]
Enable this option to enable the Smart Monitoring, Analysis, and Reporting
Technology (SMART) feature of this motherboard.
Configuration options: [Enabled] [Disabled]
Halt On [All Errors]
This field sets the system to halt on errors according to the system functions
specified in each option. Configuration options: [All Errors] [No Errors] [All, But
Keyboard] [All , But Diskette] [All, But Disk/Key]
Primary and Secondary Master/Slave
IDE Primary Master/Slave [Auto]; IDE Secondary Master/Slave [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic detection is
successful, the setup BIOS automatically fills in the correct values for the remaining fields
on this sub-menu. If automatic detection fails, this may be because the hard disk drive is
too old or too new. If the hard disk was already formatted on a previous system, the setup
BIOS may detect incorrect parameters. In these cases, select [Manual] to manually enter
the IDE hard disk drive parameters. If no drive is installed or if you are removing a drive
and not replacing it, select [None]. Configuration options: [None] [Auto] [Manual]
Access Mode [Auto]
The default [Auto] allows automatic detection of an IDE hard disk drive. Select
[CHS] for this item if you set the IDE Channel 0/1 Master/Slave to [Manual] to enter
the Hard Disk Drive values manually.
Configuration options: [CHS] [LBA] [Large] [Auto]
IDE Primary Master
IDE Primary Master [Auto]
Access Mode [Auto]
Capacity 40020 MB
Cylinder 19158
Head 16
Sector 255
Transfer Mode UDMA 2
F1 : Help ↑↓ : Select Item -/+ : Change Value F5 : Setup Defaults
ESC : Exit →← : Select Menu Enter : Select Sub-menu F10 : Save and Exit
Select Menu
Item Specific Help
To auto-detect the
HDD’s size, head...on
this channel.