Asus P5QL-EM - Manual (Page 58)

2-18 Chapter 2: BIOS setup
2.5.1. Suspend.Mode.[Auto]
Allows you to select the Advanced Configuration and Power Interface (ACPI) state to be used
for system suspend. Configuration options: [S1 (POS) Only] [S3 Only] [Auto]
[S1(POS).Only] - Enables the system to enter the ACPI S1 (Power on Suspend) sleep state.
In S1 sleep state, the system appears suspended and stays in a low
power mode. The system can be resumed at any time.
[S3.Only] - Enables the system to enter the ACPI S3 (Suspend to RAM) sleep state (default).
In S3 sleep state, the system appears to be off and consumes less power than
in the S1 state. When signaled by a wake-up device or event, the system
resumes to its working state
exactly where it was left off.
[Auto] - Detected by OS.
2.5.2. ACPI.2.0.Support.[Disabled]
Allows you to add more tables for Advanced Configuration and Power Interface (ACPI) 2.0
specifications. Configuration options: [Disabled] [Enabled]
2.5.3. ACPI.APIC.Support.[Enabled]
Allows you to enable or disable the Advanced Configuration and Power Interface (ACPI)
support in the Application-Specific Integrated Circuit (ASIC). When set to Enabled, the ACPI
APIC table pointer is included in the RSDT pointer list. Configuration options: [Disabled]
[Enabled]
2.5.4 APM Configuration
Restore.on.AC.Power.Loss.[Power.Off]
When set to Power.Off, the system goes into off state after an AC power loss. When set to
Power.On, the system goes on after an AC power loss. When set to Last.State, the system
goes into either off or on state, whatever the system state was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Power.On.By.PS/2.KB/Mouse.[Disabled]
When set to [Enabled], this parameter allows you to use the PS/2 KB/mouse to turn on the
system. This feature requires an ATX power supply that provides at least 1A on the +5VSB
lead. Configuration options: [Disabled] [Enabled]
Resume.On.Ring.[Disabled]
Allows you to enable or disable RI to generate a wake event.
Configuration options: [Disabled] [Enabled]
Resume.On.PCI.Devices.[Disabled]
When set to [Enabled], this parameter allows you to wake the system through a PCI LAN
or modem card. This feature requires an ATX power supply that provides at least 1A on the
+5VSB lead. Configuration options: [Disabled] [Enabled]
Resume.On.PCIE.Devices.[Disabled]
When set to [Enabled], this parameter allows you to wake the system through a PCI Express
card. This feature requires an ATX power supply that provides at least 1A on the +5VSB lead.
Configuration options: [Disabled] [Enabled]