Asus P5QL-EM - Manual (Page 35)

ASUS P5QL-EM 1-25
7.. Front.panel.audio.connector.(10-1.pin.AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports
either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel
audio I/O module cable to this connector.
• We recommend that you connect a high-definition front panel audio module to this
connector to avail of the motherboard’s high-definition audio capability.
• By default, this connector is set to HD Audio. If you want to connect an AC97 front panel
audio module to this connector, set the Front.Panel.Support.Type item in the BIOS to
[AC97]. See section “2.4.4 Chipset” for details.
P5QL-EM.Front.Panel.Audio.Connector
P5QL-EM
R
SENSE2_RETU
R
PO
RT
1L
PO
RT
1R
PO
RT
2R
SEBSE_SEND
PO
RT
2L
SENSE1_RETU
R
PRESENSE# GN
D
AAFP
Legacy AC’97
compliant definition
NC
MIC2
Line out_R Line out_L
NC
NC
MICPWR
NC AGND
HD-audio-compliant
pin definition
8.. Chassis.intrusion.connector.(4-1.pin.CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
P5QL-EM.Intrusion.Connector
P5QL-EM
R
CHASSIS
+5VSB_MB Chassis Signal GN
D
(Default)