Asus P9X79 - Manual (Page 86)

3-20 Chapter 3: BIOS setup
Chapter 3
CPU Current Capability [Auto]
This item provides wider total power range for overclocking. A higher value brings a wider
total power range and extends the overclocking frequency range simultaneously.
Configuration options: [Auto] [100%] [110%] [120%] [130%] [140%]
Do not remove the thermal module while changing the DIGI+ Power Control related
parameters . The thermal conditions should be monitored.
Some of the following items are adjusted by typing the desired values using the numeric
keypad and press the key. You can also use the <+> and <-> keys to adjust the
value. To restore the default setting, type [auto] using the keyboard and press the
key.
CPU VCORE Boot Up Voltage [Auto]
Use the <+> and <-> keys to adjust the value. The values range from 0.800 to 1.700 with
0.005 interval.
VCCSA Load-line calibration [Auto]
The behavior of the DRAM controller is decided by VCCSA Load-Line. Set to a higher value
for system performance, or to a lower value for better thermal solution.
Configuration options: [Auto] [Regular] [High] [Extreme]
The actual performance boost may vary depending on your CPU and DRAM specification.
Do not remove the thermal module. The thermal conditions should be monitored.
VCCSA Current Capability [100%]
Configuration options: [100%] [110%] [120%] [130%] ] [110%] [120%] [130%]
CPU VCCSA Boot Up Voltage [Auto] VCCSA Boot Up Voltage [Auto]
Use the <+> and <-> keys to adjust the value. The values range from 0.8 to 1.7 with 0.005 The values range from 0.8 to 1.7 with 0.005
interval.
CPU Voltage Frequency [Auto]
Switching frequency will affect the VRM transient response and component thermal. Setting a
higher frequency gets faster transient response.
[Auto]
Allows you to enable or disable the Spread Spectrum item.
[Manual] Allows you to manually set the frequency with a 10k Hz interval.
CPU Fixed Frequency [xxx]
Use the <+> and <-> keys to adjust the value. The values range from 300kHz to 500kHz with
10kHz interval.
CPU Spread Spectrum [Disabled]
This item helps enhance system stability.
Configuration options: [Enabled] [Disabled]