Zanussi ZHC6121X - Manual (Page 54)

54
Charcoal filter
• The charcoal filter should only be used if you
want to use the hood in the recirculation
function.
• To do this you will need an original charcoal
filter (available from your local Service Force
Centre).
• Replacing the charcoal filter
The charcoal filter cannot be washed nor
regenerated.
The charcoal filter should be replaced every 4
months under normal use.
Replacement filters are available from your
local Service Force Centre.
• Fitting
Replace the grease filter(s).
• To remove proceed in the reverse order.
• Always specify the hood model number, serial
number and product number code when
ordering replacement filters. This information
is shown on the rating plate located on the
inside of the unit.
• The charcoal filter can be ordered from your
local Service Force Centre.
R
R
S
S
S1
R1
Recirculation mode
Extraction
mode
Remove the grease filter(s).
Position the charcoal filter covering the air
suction motor protection grille so that the slots
S (and S1) on the filter are aligned with the
fixing pins R (and R1), located on each side.
Press down on the filter and turn it in a
clockwise direction until it is fixed in place
(bayonet fastening).
Make sure the internal Extraction/
Recirculation mode switch is set to
"Recirculation".