beautypg.com

36 chapter 1: product introduction, P5e-vm do front panel audio connector, Aafp – Asus P5E-VM DO User Manual

Page 48: P5e-vm do atx power connector eatxpwr, Atx12v

background image

1-36

Chapter 1: Product introduction

10. Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that

supports either HD Audio or legacy AC`97 audio standard. Connect one end

of the front panel audio I/O module cable to this connector.

• We recommend that you connect a high-definition front panel audio module

to this connector to avail of the motherboard’s high-definition audio capability.

• By default, this connector is set to [HD Audio]. If you want to connect a

AC’ 97 front panel audio module to this connector, set the Front Panel

Type item in the BIOS setup to [AC97]. See section 2.4.9 Onboard Device

Configuration for details.

R

P5E-VM DO

P5E-VM DO Front panel audio connector

HP_HD

MIC2_L

HP_R

HP_L

MIC2_JD

Jack_Sense

MIC2_R

PRESENSE#

AGND

AAFP

Legacy AC 97-compliant

pin definition

NC

MIC2_L

Line out_R

Line out_L

NC

NC

MIC2_R

NC

AGND

Azalia-compliant

pin definition

• For a fully configured system, we recommend that you use a power supply

unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)

and provides a minimum power of 400 W.

• Do not forget to connect the 4-pin ATX12V power plug; otherwise, the

system will not boot.

• Use of a PSU with a higher power output is recommended when

configuring a system with more power-consuming devices. The system

may become unstable or may not boot up if the power is inadequate.

11. ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)

These connectors are for ATX power supply plugs. The power supply plugs

are designed to fit these connectors in only one orientation. Find the proper

orientation and push down firmly until the connectors completely fit.

R

P5E-VM D

O

P5E-VM DO ATX Power connector

EATXPWR

+3 Volts

+3 Volts

Ground

+5 Volts

+5 Volts

Ground

Ground

Power OK

+5V Standby

+12 Volts

-5 Volts

+5 Volts

+3 Volts

-12 Volts

Ground

Ground

Ground

PSON#

Ground

+5 Volts

+12 Volts

+3 Volts

+5 Volts

Ground

ATX12V

GN

D

+12V DC

GND

+12V DC

This manual is related to the following products: