Asus RS260-E3/RS8 - Manual (Page 75)

A S U S R S 2 6 0 - E 3 A S U S R S 2 6 0 - E 3 A S U S R S 2 6 0 - E 3 A S U S R S 2 6 0 - E 3 A S U S R S 2 6 0 - E 3 4 - 1 1 4 - 1 1 4 - 1 1 4 - 1 1 4 - 1 1
4.5 Connectors
This section describes the internal connectors on the motherboard. Refer
to section “1.4 Rear panel features” for information on the external (rear
panel) connectors.
1 . 1 . 1 . 1 . 1 . F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 ) F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 ) F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 ) F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 ) F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the
floppy drive. (Pin 5 is removed to prevent incorrect insertion when using
ribbon cables with pin 5 plug).
®
PVL-D/2U/SCSI
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
FLOPPY1
PVL-D/2U/SCSI Floppy disk drive connector
2 . 2 . 2 . 2 . 2 . H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 ) H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 ) H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 ) H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 ) H a r d d i s k a c t i v i t y L E D c o n n e c t o r ( 4 - p i n H D L E D 1 )
This connector supplies power to the hard disk drive activity LED. The
read or write activities of any device connected to an add-on SCSI card
or RAID card cause this LED to light up.
®
PVL-D/2U/SCSI
PVL-D/2U/SCSI SCSI/SATA card activity LED connector
HDLED1
1
SCSI_ACTLED- SCSI_ACTLED+ SCSI_ACTLED+ SCSI_ACTLED-