Asus RS260-E3/RS8 - Manual (Page 35)

A S U S R S 2 6 0 - E 3 A S U S R S 2 6 0 - E 3 A S U S R S 2 6 0 - E 3 A S U S R S 2 6 0 - E 3 A S U S R S 2 6 0 - E 3 2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5
2.3.2 2.3.2 2.3.2 2.3.2 2.3.2 Installing a DIMM Installing a DIMM Installing a DIMM Installing a DIMM Installing a DIMM
Make sure to unplug the power supply before adding or removing DIMMs or
other system components. Failure to do so may cause severe damage to
both the motherboard and the components.
Follow these steps to install a DIMM.
1. Unlock a DIMM socket by pressing
the retaining clips outward.
2. Align a DIMM on the socket such
that the notch on the DIMM
matches the break on the socket.
3. Firmly insert the DIMM into the
socket until the retaining clips snap
back in place and the DIMM is
properly seated.
1. Simultaneously press the retaining
clips outward to unlock the DIMM.
2. Remove the DIMM from the socket.
2.3.3 2.3.3 2.3.3 2.3.3 2.3.3 Removing a DIMM Removing a DIMM Removing a DIMM Removing a DIMM Removing a DIMM
Follow these steps to remove a DIMM.
Support the DIMM lightly with
your fingers when pressing the
retaining clips. The DIMM might
get damaged when it flips out
with extra force.
U n l o c k e d r e t a i n i n g c l i p U n l o c k e d r e t a i n i n g c l i p U n l o c k e d r e t a i n i n g c l i p U n l o c k e d r e t a i n i n g c l i p U n l o c k e d r e t a i n i n g c l i p
L o c k e d r e t a i n i n g c l i p L o c k e d r e t a i n i n g c l i p L o c k e d r e t a i n i n g c l i p L o c k e d r e t a i n i n g c l i p L o c k e d r e t a i n i n g c l i p