Asus SP97-XV - Manual (Page 27)

ASUS SP97-XV User’s Manual 27
III. INSTALLATION
(Connectors)
III. INST
ALLA
TION
8. Primary / Secondary IDE connectors (Two 40-1pin IDE)
These connectors support the provided IDE hard disk ribbon cable.
After connecting the single end to the board, connect the two plugs at the other
end to your hard disk(s). If you install two hard disks, you must configure the
second drive to Slave mode by setting its jumper accordingly. Please refer to the
documentation of your hard disk for the jumper settings. (Pin 20 is removed to
prevent inserting in the wrong orientation when using ribbon cables with
pin 20 plugged).
R
Primary IDE Connector
Pin 1
Secondary IDE Connector
IDE Connectors
NOTE: Orient the red stripe to Pin 1
9. IDE activity LED (4-1pin IDE_LED)
This connector supplies power to the cabinet’s IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE connectors
will cause the LED to light up.
R
IDE Activity LED
TIP: If the case-mounted LED does not light,
try reversing the 2-pin plug.
+5V
IDE Signal