Asus SP97-XV - Manual (Page 16)

16 ASUS SP97-XV User’s Manual
III. INSTALLATION
(Jumpers)
III. INST
ALLA
TION
5. Voltage Regulator Output Selection (VID0, 1, 2)
These jumpers set the voltage supplied to the CPU.
Intel Pentium (P54C)
(75MHz-200MHz) Pentium MMX (P55C)
(150MHz-233MHz) AMD-K6
(PR166 and faster) AMD-K5
(PR75-PR133) IBM/Cyrix 6x86(MX)
(PR166 and faster) IBM/Cyrix 6x86(M1)
(PR166 and faster)
WARNING! Because CPU designs change rapidly, the table below is only in-
tended as a simple guideline and thus may not be true for your CPU. Always
refer to the CPU documentation for your CPU’s voltage and then set the appro-
priate VID jumpers according to the illustration below.
Manufacturer CPU Type Single Plane Dual Plane VID2 VID1 VID0
Intel P54C/P54CS 3.5V(VRE) ---- [2-3] [2-3] [1-2]
AMD K5 3.5V(VRE) ---- [2-3] [2-3] [1-2]
IBM/Cyrix 6x86 3.5V(VRE) ---- [2-3] [2-3] [1-2]
Intel P54C/P54CS 3.4V(STD) ---- [2-3] [2-3] [2-3]
AMD K5 3.4V(STD) ---- [2-3] [2-3] [2-3]
AMD (.35micron) K6-PR233 ---- 3.2V(Dual) [1-2] [2-3] [2-3]
AMD (.35micron) K6-166,200 ---- 2.9V(Dual) [2-3] [2-3] [1-2]
IBM/Cyrix 6x86MX ---- 2.9V(Dual) [2-3] [2-3] [1-2]
Intel P55C-MMX ---- 2.8V(Dual) [2-3] [2-3] [2-3]
AMD (.25micron) K6-233,266,300 ---- 2.1V(Dual) [2-3] [2-3] [1-2]
R
Note: Auto-voltage detection regulators allow some
jumper settings to be the same for two voltages. Voltage Regulator Output Selection
1
2
3
3.2 Volts
1
2
3
2.8/3.4 Volts
1
2
3
2.9/3.5 Volts
1
2
3
2.5 Volts
VID1 VID0 VID2
1
2
3
2.7 Volts
VID1 VID0 VID2 VID1 VID0 VID2
1
2
3
2.1 Volts