Asus AT4NM10T-I - Manual (Page 24)

ASUS AT4NM10T-I 1-14
8. System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
AT4NM10T-I
AT4NM10T-I System panel connector
PIN 1
PWR BTN
PLED
+
PLED
-
PWR GND
HD_LED
+
HD_LED
-
Groun
d
Rese
t
F_PANEL
PWR LED
HD_LED RESET
• System power LED (2-pin PWR LED)
This 2-pin connector is for the system power LED. Connect the chassis power LED
cable to this connector. The system power LED lights up when you turn on the system
power, and blinks when the system is in sleep mode.
• Hard disk drive activity LED (2-pin HD_LED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED cable
to this connector. The HD LED lights up or flashes when data is read from or written to
the HDD.
• ATX power button/soft-off button (2-pin PWRBTN)
This connector is for the system power button.
• Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system reboot without
turning off the system power.
9. LVDS connector (30-pin LVDS)
This connector is for a LCD monitor that supports Low-voltage differential signaling
(LVDS) interface.
AT4NM10T-I
AT4NM10T-I LVDS connector
LVDS
PIN 1
GN
D
VC
C
VC
C
GN
D
VEEDID LCD_PID0 LCD_PID1 LDDC_CS# DDC DATA DDC CL
K
VLED VLED VLED VLED VLED_GND
BLIM
BL_O
N
GND
DATA_0
-
DATA_0
+
GDN
DATA_1
-
DATA_1
+
GND
DATA_2
-
DATA_2
+
GND CLK- CLK+ GND