Asus AT4NM10T-I - Manual (Page 22)

ASUS AT4NM10T-I 1-12
4. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
AT4NM10T-I
AT4NM10T-I Chassis intrusion connector
+5VSB_M
B
Chassis Signal GN
D
CHASSIS
5. Internal speaker connector (4-pin SPEAKER)
The 4-pin connector is for the chassis-mounted system warning speaker. The speaker
allows you to hear system beeps and warnings.
AT4NM10T-I
AT4NM10T-I
Speaker Out Connector
+5
V
GN
D
GN
D
Speaker Out
SPEAKER
PIN 1