Asus AT4NM10T-I - Manual (Page 21)

1-11 Chapter 1: Product introduction
2. Serial ATA connectors (7-pin SATA_1, SATA_2, SATA_E1, SATA_E2)
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical drives via
Serial ATA 3.0 Gb/s signal cables.
GN
D
RSATA_RXN1 RSATA_RXP1 GN
D
RSATA_TXN1 RSATA_TXP1 GN
D
SATA3G_E2
SATA3G_E1
GN
D
RSATA_TXP2 RSATA_TXN2
GN
D
RSATA_RXP2 RSATA_RXN2
GN
D
GN
D
RSATA_RXN1 RSATA_RXP1 GN
D
RSATA_TXN1 RSATA_TXP1 GN
D
SATA3G_2
SATA3G_1
GN
D
RSATA_TXP2 RSATA_TXN2
GN
D
RSATA_RXP2 RSATA_RXN2
GN
D
AT4NM10T-I
AT4NM10T-I SATA 3.0Gb/s connectors
• Install the Windows ® XP Service Pack 3 or later version before using Serial ATA.
• The SATA3G_E1/E2 (black) connectors are for data drives only. ATAPI device is not
supported.
3. USB connectors (10-1 pin USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
This USB connector complys with USB 2.0 specification that supports up to 480 Mbps
connection speed.
AT4NM10T-I
AT4NM10T-I USB2.0 connector
PIN 1
USB+5V USB_P8- USB_P8+ GN
D
NC
USB+5V
USB_P7- USB_P7+
GN
D
USB78
Never connect a 1394 cable to the USB connector. Doing so will damage the motherboard!
The USB module cable is purchased separately.