Asus P5GC - Manual (Page 52)

2-30 Chapter 2: Hardware information
11.. System.panel.connector.(20-8.pin.F_PANEL)
This connector supports several chassis-mounted functions.
P5GC.System.Panel.Connector
P5GC
*
Requires an ATX power supply
NEL
PLED
-
PW
R
+5
V
Speake
r
Ground
RESET
Ground Reset
Ground Ground
PWRSW
PLED
+
IDE_LED- IDE_LED+
IDE_LED
PLED SPEAKER
PA
•. System.power.LED.(2-pin.PLED)
This 2-pin connector is for the system power LED. Connect the chassis power
LED cable to this connector. The system power LED lights up when you turn on
the system power, and blinks when the system is in sleep mode.
•. Hard.disk.drive.activity.LED.(2-pin.+IDE_LED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED
cable to this connector. The IDE LED lights up or flashes when data is read
from or written to the HDD.
•. System.warning.speaker.(4-pin.SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The
speaker allows you to hear system beeps and warnings.
•. ATX.power.button/soft-off.button.(2-pin.PWRSW)
This connector is for the system power button. Pressing the power button turns
the system on or puts the system in sleep or soft-off mode depending on the
BIOS settings. Pressing the power switch for more than four seconds while the
system is ON turns the system OFF.
•. Reset.button.(2-pin.RESET)
This 2-pin connector is for the chassis-mounted reset button for system reboot
without turning off the system power.