Asus Crosshair III Formula - Manual (Page 59)

2. AMD ® SB750 Southbridge Serial ATA connectors (7-pin SATA1–5)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
and optical disk drives.
If you install SATA hard disk drives to the SATA1–5 connectors, you can
create a RAID 0, RAID 1, RAID 5, RAID 10 or JBOD configuration through
the onboard AMD ® SB750 controller.
These connectors are set to [IDE] by default. If you intend to create a Serial ATA
RAID set using these connectors, set the Onchip SATA Type item in the BIOS to
[RAID].
Install the Windows ® XP Service Pack 2 or later version before using Serial ATA.
• For detailed instructions on how to configure RAID 0, RAID 1, RAID 5 and
RAID 10, refer to the RAID manual in the support DVD.
• If you intend to create a Serial ATA RAID set using these connectors, set
the OnChip SATA Type item in the BIOS to [RAID].
ROG Crosshair III Formula 2-31