Asus P5VD2-MX SE - Manual (Page 37)

ASUS P5VD2-MX SE Motherboard 1-27
5. ATX power connectors (2-pin EATXPWR, -pin ATX12V)
These connectors are for ATX power supply plugs. The plugs from the power
supply are designed to fit these connectors in only one orientation. Find the
proper orientation and push down firmly until the connectors fit completely.
• Do not forget to connect the 4-pin ATX +12V power plug; otherwise, the
system does not boot up.
• Make sure that your ATX 12V power supply can provide 12A on the +12V
lead and at least 1A on the +5-volt standby lead (+5VSB). The minimum
recommended wattage is 300 W, or 350 W for a fully configured system.
The system can become unstable or will not boot up if the power is
inadequate.
6. Speaker out connector (-pin SPEAKER)
This connector is for the case-mounted speaker and allows you to hear system
beeps and warnings.
P5VD2-MX SE ATX Power Connectors
ATX12V
+12V DC
GND
+12V DC
GND
EATXPWR
+3 Volts
+3 Volts
Ground
+5 Volts
+5 Volts
Ground
Ground
Power OK
+5V Standby
+12 Volts
-5 Volts
+5 Volts
+3 Volts
-12 Volts
Ground
Ground
Ground
PSON#
Ground
+5 Volts
+12 Volts
+3 Volts
+5 Volts
Ground
P5VD2-MX SE
P5VD2-MX SE Speaker Out Connector
SPEAKER
+5V
GND
GND
Speaker Out
1
P5VD2-MX SE