Zanussi ZBB29450SA - Manual (Page 24)

Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate corre-
spond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Door reversibility
The door of the appliance opens to the right. If
you want to open the door to the left, do these
steps before you install the appliance:
1
Loosen the upper
pin and remove the
spacer.
2
Remove the upper
pin and the upper
door.
3
Loosen the middle
hinge.
4
Remove the lower
door.
4
Loosen the lower
pin.
On the opposite side:
1
Install the lower
pin.
2
Install the lower
door.
3
Tighten the middle
hinge.
4
Install the upper
door.
5
Tighten the
spacer and the upper
pin.
Ventilation requirements
The airflow behind
the appliance must
be sufficient. 5 cm
min. 200cm 2
min.
200cm 2
Installing the appliance
Caution! Make sure that the mains cable
can move freely.
Do the following steps:
24
www.zanussi.com